I was alerted by a customer on our forum of a quality issue.  The last batch of Lemon-Rx DESC boards had at least a few boards that were assembled incorrectly.

The calibration header was soldered one slot over from the correct position.  This means that the board will not calibrate and the elevator channel is not connected to the lemon!  

The soldered connection in the photo below should be in the green circle not the red circle.

I 100% accept responsibility for this error.  As we jig test prior to lemon rx assembly this was not caught in our quality process.  I have added another step to our quality checklist to ensure this will not happen in the future.

Orders Prior to February 19th are likely not affected (as this is from a new production batch)

Future orders will not have this problem.

If you have a board that is affected (you should have received an email warning you about this issue)  Please email Sales@endbots.com letting me know the order number and number of affected boards and I will send you replacement boards.  You can keep the affected boards and attempt to fix the wiring if you choose.

I apologize for any inconvenience this may have caused.

Sincerely,

Jeffrey Olijar, Endbots.com

I was alerted by a customer on our forum of a quality issue.  The last batch of Lemon-Rx DESC boards had at least a few boards that were assembled incorrectly.

The calibration header was soldered one slot over from the correct position.  This means that the board will not calibrate and the elevator channel is not connected to the lemon!  

The soldered connection in the photo below should be in the green circle not the red circle.

I 100% accept responsibility for this error.  As we jig test prior to lemon rx assembly this was not caught in our quality process.  I have added another step to our quality checklist to ensure this will not happen in the future.

Orders Prior to February 19th are likely not affected (as this is from a new production batch)

Future orders will not have this problem.

If you have a board that is affected (you should have received an email warning you about this issue)  Please email Sales@endbots.com letting me know the order number and number of affected boards and I will send you replacement boards.  You can keep the affected boards and attempt to fix the wiring if you choose.

I apologize for any inconvenience this may have caused.

Sincerely,

Jeffrey Olijar, Endbots.com

Older Post Newer Post

0 comments

Leave a comment