Arduino Compatible UNO Clone


Out of stock

This is a low cost clone of the Arduino UNO.  If you are looking for a low cost solution for your microcontroller needs then this is the board for you. 

Note: This board uses the CH340 Driver instead of the FTDI Driver

USB Cable is not included

Official version available here   


  • Microcontroller: ATmega328P
  • Operating Voltage: 5V
  • Input Voltage (recommended) 7-12V
  • Digital I/O Pins 14 (of which 6 provide PWM output)
  • Analog Input Pins 6
  • DC Current per I/O Pin 20 mA
  • DC Current for 3.3V Pin 50 mA
  • Flash Memory 32 KB of which 0.5 KB used by bootloader
  • SRAM 2 KB 
  • EEPROM 1 KB 
  • Clock Speed 16 MHz
  • Length 68.6 mm
  • Width 53.4 mm
  • Weight 25 g

Customer Reviews

Based on 3 reviews Write a review